Roofing Equipment & Boilers Surfacing Plant Tools & Equipment Bitumen Boilers Safety Accessories Spare Parts Accessories & Gas Torches Thermometers LPG, 'Impact' & 'Petal' Industrial Gas burners Thermostat & Boiler Control Jointing & Marking shoes & tools Low Temperature/Polymer/Rubber Materials Agricultural & Marine Cookers

Farvis - Engineering since 1840

“Quality at Trade Prices”

All Farvis Products are design copyrighted

The Pan

Please use imperial measurements- i.e. inches!!

We only need to know the details of the part you require - however please be sure to say what part you have measured and what you want!

If you prefer, we can send you a dimension sheet that you can fill in and fax back.


Not only do we need the sizes, but we also need the item to be measured in the correct  place - then we both know that we are talking about the same thing!

We need to know the diameter of the pan and the height of the pan wall to the top.   You may have to remove bitumen and dirt to get the measurement and we don't need it to be exact, but we will need you to be accurate to within 1/4 of an inch.


Look at the two photographs and record the measurements.

PAN INTERNAL DIAMETER IN INCHES  (inside edges )

PAN HEIGHT IN INCHES

DOES THE PAN HAVE A TAP SOCKET?

This is fitted during manufacture and we MUST know when you order!

See taps & Sockets Page for Measurement Guide