FARVIS offer a range of thermoplastic heating and mixing equipment. We specialise in smaller units of 10 & 25 gallon size that can be used in side streets, car parks and for marking factory floors, and also for reinstatement and patching work.
A baby thermoplastic heater-mixer in an easy to move, easy to use, low cost package.
Easy to use, these are very versatile and provide a fast and easy way to heat and dispense small quantities of white line material when it is not economic to use a big machine.
Hand turned paddles are easy, cheap and efficient in smaller sizes and save a fortune in cost! They are not difficult to use and enable quick and easy operation for smaller jobs. Our MIXMASTER (c) system is quick to use, easy to clean and highly effective.
Hand paddle mixing - low cost, effective and efficient.
Heaters can be fitted with all our standard accessories including thermostat control and come with a hand turned paddle unit, a half opening lid which can be removed if required, and two easy to turn sweeps for mixing and stirring the material. The mixing unit can be removed in a few minutes for cleaning.
Our incredibly versatile pre heaters can be used to dispense directly into pouring cans and buckets using our special 40 mm and 75 mm thermoplastic thro-flow dispensing taps.
Special thro flow thermoplastic tap.
... tools ...
We supply a range of special marking shoes with ergonomic handles and tilting heads for easy and accurate line marking. Sizes range from1" ( 25 mm ) to 8" ( 200 mm ).
Marking and overbanding shoes.
Low cost easy to use units that provide flexibility, fast heating and a low outlay.
Fast and efficient heating and mixing of thermoplastics and grouts.
Ideal for smaller jobs and difficult to reach spaces.
.... and they are mobile too ...
Trolley mounted heater-stirrer for thermoplastic paint. This unit carries a gas cylinder in a protected enclosure and is an entirely self contained mobile thermoplastic pre heater.
Heater mixer units can be supplied as free standing, trolley mounted for low speed towing, trailer mounted or fitted to a small self contained sled that can be fork lifted onto a pickup or small lorry for occasional use. This frees up the vehicle for daily operations but enables the boilers to be transported efficiently and easily when necessary. They do not take up much space in store or on a vehicle.
FARVIS double thermostat temperature controlled 40 gallon hand mixer units on a demountable sled.
Double sled mounted 25 gallon heater mixers .
... and when you need to replace existing preheaters units, FARVIS provide the low cost answer ...
Partly built - and unpainted ( ! ) - 'twin 30's' for a customer to install, paint & motorize.
.... we build you a pre heater and the stirring gear - your fitters add your existing drive system.....
For larger requirements we now offer pre fabricated heater mixer units, built to replace a worn out boiler and ready to accept the agitation and stirring gear from your existing machine. This is much cheaper than buying a complete new unit.
We supply 50 gallon units and thermostats if required, with the burner system installed, ready for you to mount your existing gearboxes and drives.
We make the boiler and thermostat control (if required), supply the mixer shaft, outlet tap, paddles and bearings with the gearbox/gear-motor mountings pre cut ready for your fitters to install your existing drive units and accessories .
60 gallon thermostat heater unit with pre assembled mixing paddles for customer to mount his own special drive motor and hydraulic system. The structure on top is to take a particular drive system to meet our customer's requirements. This unit included a thermostat and special wide bore valve.(c)
All units are built to extremely heavy duty specification.
We don't skimp on materials or build quality.